←
IxTech5,705 posts
IxTech avatar

IxTech

@IxTechCrypto

Bitaxe & Nerdaxe Bitcoin Mining, 3D Printed Accessories &Home Miner Repair | Building for Bitcoin⛏️🟧 |🪖USMC OIF Vet

◷ Joined April 2020▧ 1,927 Photos and videos
IxTech avatar
IxTech@IxTechCrypto·Nov 11

New video is live! 🚨 Check out our latest breakdown of the V-Reg Active Cooling Kit for the NerdQaxe Hydro + and ++. Pushing your hash rate? Don't let your voltage regulators overheat. Learn how to split your ASIC and V-reg fan control to keep those temps exactly where you want them. ❄️📉 Watch the full install and dashboard setup..link in comments👇👇

Post attachment
IxTech avatar
IxTech@IxTechCrypto·3h

Honest question for home miners: what's actually driving it for you?

Insult Supply®️ avatar
⟳ IxTech retweeted
Insult Supply®️@InsultSupply·13h

Totally loving my new @IxTechCrypto Gekkoaxe GT kit! Looks like none of my other miners, and it's almost 1 Th higher hashrate than stock setup while STILL on default settings.. This thing just needed to breath.. 🎉

Post attachmentPost attachmentPost attachment
IxTech avatar
IxTech@IxTechCrypto·22h

Let's get this repaste going. I am going to walk through it once then I'll repaste another so I can do a before/after then film for YT

Post attachment
IxTech avatar
IxTech@IxTechCrypto·Nov 17

There’s been a lot of unnecessary noise and backlash aimed at veterans on X lately. Instead of feeding into the negativity, we want to use our platform to lift our community up. We are a proud veteran-owned business, and we believe in having each other's backs—in uniform and out. Drop your veteran-owned business below, or tag a veteran creator, founder, or entrepreneur in the comments. Let’s get eyes on their work, boost their reach, and show some real support. 🇺🇸👇

IxTech avatar
IxTech@IxTechCrypto·Nov 16

We cookin..🍳

0:11
IxTech avatar
IxTech@IxTechCrypto·Nov 15

Spent the day chasing heat on my Nano 3S. Baffles, a 3D-printed shroud, 2x Arctic P8 on intake, then a 140mm Noctua iPPC-3000 on exhaust. Fans dropped from 55% to 38%. Hottest chip still sits at 88°C, 11°C hotter than the chip right next to it. That's not airflow. Time to repaste.

Post attachmentPost attachment
IxTech avatar
IxTech@IxTechCrypto·Nov 14

Found if I run the plan settings but up the temp to 230, I can print petg. Also, was able to use up the little rolls of petg I had.

Post attachment
IxTech avatar
IxTech@IxTechCrypto·Nov 13

Testing the power target setting for the nano3s... with a meanwell 200-24 hooked up.... Still pretty good.. rejections getting up there, but not too bad. 🤞🤞

Post attachmentPost attachment
IxTech avatar
IxTech@IxTechCrypto·Nov 13

The hash is flowing and the plasma is glowing on the nano3s 🔥

0:04