


"Design - Build - Fly". Innovative technological solutions to produce competitive Autonomous Unmanned Aerial Systems


Join us on taking a look at what went into building this incredible machine and where we will be taking Vulcan and Project Hex from here as we learn from our experiences and prepare for the SUAS 2024 Competition.

To this end we will be publishing a wave of new content on all our social media channels including lots of incredible flight footage.

Even though we couldn't make it to the competition this time around we would like to present to the world all the hard work and dedication that the team put into building our beloved Vulcan and show this beast of an Unmanned Aerial Vehicle taking to the skies.

We’d like to especially highlight Skylift for their generous support with the flight testing of Vulcan. Their advice and support was integral to getting us flying and we hope to continue working with them in the near future.

The team has performed a thorough investigation of the cause of the incident and have already implemented improvements for the next iteration to prevent the same failure mode from ever taking place again.

Thank you to all our sponsors, partners and supporters for your continued faith in us and we’re confident version 3 of Vulcan will not disappoint!

Whilst this was a sad loss for the team we remain as motivated as ever to bounce back stronger. The team has gained a wealth of knowledge , cementing ourselves as leaders in student-led drone projects, having built the largest VTOL UAV ever built at the University of Sheffield.

Late April our Vulcan UAV suffered an unforeseeable failure resulting in the destruction of the airframe at our test site. As this took place during the final stages of our flight testing, shortly ahead of the SUAS Competition, we unfortunately had to withdraw this year's entry.


It’s near impossible to visualise a full-scale model as ambitious as Vulcan—but now we don’t have to. The pre-epoxy dry fit gave us our first ever chance to fully take in the results of our structures and manufacturing teams’ hard work. We can’t wait to share more as we progress!

With our global FEA model, we faced some unique obstacles inherent to the scale of our analysis and the resources available. Nevertheless, we’re proud to say that we’ve come away from it feeling confident and reassured. Find out more on our other platforms!

Although we’ve found that both materials would have acceptable stresses even through the worst, we’re opting for carbon fibre for its lower weight and higher factor of safety. To save even more weight, we’ll soon be analysing a series of optimised rib variants using FEA!

We’ve been analysing the stresses on the ribs under expected conditions and a worst-case scenario to figure out where the weak points are and how they’ll hold up. Our objectives have focused on materials (should we use aluminium or carbon fibre?) and the bolted connections.

FEA software can approximate the stresses and deformation of a model by breaking it down into small elements and nodes using a mesh. But the range of assumptions, limitations, and simplifications to consider are what make it so complex to get right.

Sturdy connections between the wing and the booms — key components of a twin-boom aircraft — are vital for a UAV’s flight readiness. Vulcan’s attachment ribs were analysed by Adam Dunn, who joined the team this year with valuable FEA experience gained from his year in industry.