
Coat hooks screwed into the back of a meeting room fire door are easy to miss. 🧥 Two more: - noticeboards fixed through the leaf - bolts added for privacy Each one changes a tested door. 🌐 protestesltd.co.uk?utm_sourc… 📞 01604 696113

⚡️ Electrical & Passive Fire Safety Specialists 🔥

Coat hooks screwed into the back of a meeting room fire door are easy to miss. 🧥 Two more: - noticeboards fixed through the leaf - bolts added for privacy Each one changes a tested door. 🌐 protestesltd.co.uk?utm_sourc… 📞 01604 696113

Cracked glass in a fire door vision panel matters because the glass, beads and glazing seal were all part of what the door was tested with. 🪟 The replacement has to match that evidence too. When did anyone last check yours? 🔍

Riser access panel leaning against the corridor wall, and the opening behind it left wide open into the riser. If the riser wall is fire-resisting, that panel is part of it. protestesltd.co.uk/fire-comp…

A slamming fire door usually needs its closer adjusted in small turns, then testing from every angle so it still latches. protestesltd.co.uk/fire-door…

We check old hardware holes on every door and either repair them to the evidence or tell you plainly that the leaf needs replacing: protestesltd.co.uk/fire-door…

Small redundant screw holes can often be made good with a method the manufacturer allows. A bigger cut-out needs a proper look, and sometimes it's the reason the leaf has to be replaced.

Filler, a timber patch or a plate screwed over the hole won't put back what was cut out. The door's fire performance rests on its test evidence, and general-purpose filler isn't part of that.

From the corridor it reads as a slightly lumpy patch on the door edge, so it's an easy one to tick off on a walk-round and move on.

Somebody swapped the lock on the plant room fire door a while back, and the old cut-out is still there under a smear of wood filler and a coat of paint. 🔩

Extinguishers are what we find propping fire doors open most often. 🧯 Close behind: - a bin against the leaf - folded cardboard under the edge - a chair from the next office - a cable tie on the closer protestesltd.co.uk/?utm_sour… 01604 696113

Daylight down the middle of a pair of double fire doors, where the leaves should meet, is a defect we'd fix early. 🚪 Usually it's a dropped leaf or worn hinges, and smoke finds that gap first. 🔧 How many of your double doors meet tight?

Plastic waste pipe through the riser floor, no collar on it and an open gap all the way round. In a fire that pipe softens and burns away, leaving a hole to the floor above, so it needs a tested collar. protestesltd.co.uk/fire-stop…

No law sets an expiry date for a fire door. Traffic, environment, installation, maintenance and hardware decide how long one lasts. protestesltd.co.uk/fire-door…

Swapping it for the correct hinge is a short job. We fit it, photograph it and record it against the door reference, so the fix shows on paper too: protestesltd.co.uk/fire-door…

At the next inspection it gets picked up straight away. Hinges on a fire door have to suit that door's test evidence, usually made to BS EN 1935 for fire door use, with the right screw in every hole and intumescent pads where the door calls for them.

It's shinier than the other two and a slightly different size. The door still swings shut, so nobody gave it a second thought.